BLADE_ID_STOP_SCAN_WHILE_IGNITED - I think this needs work. I found that lighting the blade was fine, but when you shut down, as the blade is just starting to retract, it starts trying to scan again which messes up the retraction. With no blade fitted you get garbled lights on the neo blade connector. Admittedly I’m only using snapshotid, so might be different with externalpullup, but I don’t have a hilt to test that. I do still also find I get quite a few false reads, where it’s sat idle, then suddenly decides the value has changed, starts to play the font ident, then thinks, “Oh no, it hasn’t changed after all.” But again, that might be the fault of snapshotid.
BLADE_ID_STOP_SCAN_WHILE_IGNITED - I think this needs work. I found that lighting the blade was fine, but when you shut down, as the blade is just starting to retract, it starts trying to scan again which messes up the retraction. With no blade fitted you get garbled lights on the neo blade connector. Admittedly I’m only using snapshotid, so might be different with externalpullup, but I don’t have a hilt to test that. I do still also find I get quite a few false reads, where it’s sat idle, then suddenly decides the value has changed, starts to play the font ident, then thinks, “Oh no, it hasn’t changed after all.” But again, that might be the fault of snapshotid.