TFT file for 5 inch display uploaded.
V 1.5 Bug fixed. Touch disabled when TX.
V 1.4 Arduino-LDMOS-SSPA-Controller-v1.4.ino Pin assignment corrected for PCB V1.1
V 1.3 Arduino-LDMOS-SSPA-Controller-v1.3.ino Arduino LDMOS SSPA controller with Nextion HMI display
Features:
- Arduino Nano [easy code to understand]
- Max watt, max SWR, Max Temp for Bar graph settings can be changed in Arduino code.
- Display Power output in bar graph and numeric
- Display SWR in bar graph and numeric
- Display Temp in bar graph and numeric
- Display Band in Numeric, also band button shows current display. Touch button for band selection.
- Antenna 2 selection (optional - currently no GPIO left)
- Shows FAN speed (LOW/MID/HIGH/HOT/ALRM)
- Band change by 8 pole rotary band switch (position 1 will enable touch switch).
- No Band change when TX on, if you change band switch or select different band from touch - it will change when TX goes of.
- PWM FAN control depends on temperature.
- Temp sensor DS18B20 3 pin IC
- Volt monitor.
- Current monitor from DXWORLD-E protection board (BTS.....)
- Shows SWR/High Po/High current LED status on LCD
- Shows PTT status (on air)
- Shutdown bias V at 54.9 Degree (you can set it)
- Shows operator callsign on front display (change it inside Arduino code)
- For touch band selection, band change memorize in eeprom, comes back same band after power on or reset.
If you need any clarification or help raise a "issues" here in GIT, or drop me an email.
Enjoy, 73, S21RC